MCQ of electrical and physics/ studybuddy

Electrical engineering and simple physics MCQ with answers.

1.What is Ohm's Law used to calculate?

a) Voltage

b) Current

c) Resistance

d) Power

2.What is the unit of electrical resistance?

a) Coulomb

b) Volt

c) Ohm

d) Watt

3.How is alternating current (AC) different from direct current (DC)?

a) AC has a higher voltage than DC

b) AC changes direction, while DC does not

c) AC is more efficient than DC

d) AC is less expensive than DC

4.What is a transformer used for in an electric circuit?

a) To increase the voltage

b) To decrease the voltage

c) To increase the current

d) To decrease the resistance

5.What is a diode used for in an electric circuit?

a) To rectify AC to DC

b) To amplify a signal

c) To store electrical energy

d) To switch the circuit on and off

Comments

What is two transistor model of scr ? Explain SCR

Power electronics Two Transistor Model of SCR full explain and pdf. Basic operating principle of SCR, can easily be understood by the two transistor model of SCR , as it is a combination of p and n layers. This is a pnpn thyristor. If we bisect it through the dotted line then we will get two transistors i.e. one pnp transistor with J 1 and J 2 junctions and another is with J 2 and J 3 junctions as shown in figure below. The relation between the collector current and emitter current is shown below Here, I C is collector current, I E is emitter current, I CBO is forward leakage current, α is common base forward current gain and relationship between I C and I B is Where, I B is base current and β is common emitter forward current gain. Let’s for transistor T 1 this relation holds And that for transistor T 2 Now, by the analysis of two transistors model we can get anode current, From equation (i) and (ii), we get, If applied gate current is I g then cathode current will b...

If K is the transformation ratio, then the secondary phase voltage of delta-delta connected three phase transformer will be

Delta-Delta Connection in Three Phase Transformers - MCQs with Answers Q1. If K is the transformation ratio, then the secondary phase voltage of delta-delta connected three phase transformer will be. a. 1 / K times of the primary phase voltage b. Equal to the primary phase voltage c. 1 / K ∧ 2 times of the primary phase voltage d. K times the primary phase voltage ANSWER: d. K times the primary phase voltage

BISECTION METHOD (BOLZANO METHOD) / what is BISECTION METHOD (BOLZANO METHOD)

Explain BISECTION METHOD (BOLZANO METHOD). Engineering maths The method is applicable for numerically solving the equation f ( x ) = 0 for the real variable x , where f is a continuous function defined on an interval [ a , b ] and where f ( a ) and f ( b ) have opposite signs. In this case a and b are said to bracket a root since, by the intermediate value theorem , the continuous function f must have at least one root in the interval ( a , b ). At each step the method divides the interval in two by computing the midpoint c = ( a + b ) / 2 of the interval and the value of the function f ( c ) at that point. Unless c is itself a root (which is very unlikely, but possible) there are now only two possibilities: either f ( a ) and f ( c ) have opposite signs and bracket a root, or f ( c ) and f ( b...

Study

Search This Blog